★★★★★ 4
Easy Install Onto Jeep JKU, No Switch Backlight or Mounting Holes, Great Customer Service
Color: 5in Cube LED Pod, Color: 5in Cube LED Pod
I installed the Auxbeam 5" 168W LED Cube Pods onto my Jeep JKU Anniversary Steel Bumper. It was an easy install with some YouTube videos to help me snake the cables into the cab.
The unused holes in the steel bumper were the perfect size to fit the mounting bolts on the pod lights, and there was plenty of room to reach under the top edge of the bumper to install the nuts with some Loctite.
To snake the provided cable through the firewall, I had to remove the installed socket. This was easy to do by simply recessing the retainer clip on each pin, taking a picture of the wired connector before releasing the wires so I knew how to reassemble, snaking the connectorless cable through the firewall into the cab where the pins were then reinserted and locked into the connector. I dressed the cable by zip tie to the existing wire harness at the top of the engine bay. In the cab, I pulled the side panel from the dash (driver's side) and made a small hole for the cable in the panel. After cleaning the dash with alcohol, the adhesive-backed switch seems to hold nicely in place.
The lights were very bright and did a great job of illuminating the front and sides of the trail ahead of me.
No backlight on the switch, which is a necessity, and I dont understand why that feature is not present.
Also, there is no through hole to mount as the adhesive back won't stay attached, so the lack of a mounting hole is a big negative as well.
5 Month UPDATE: One of the lights got water inside. I noticed two screws that hold the glass cover were loose on the bottom of both sides. The other light also had the same loose screws but no water under the glass. I contacted Auxbeam, and they replaced the entire set in 2 days. Very awesome customer service.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 25, 2023
,
and
Promo Codes Available: